• Step 1

    Have your device ready on a soft, lint-free towel. Make sure the device is OFF. Unpack your WoopSkinz box so that your squeegee, spray bottle, and WoopSkinz are ready to go.

    installation-step-1
  • Step 2

    Spray your fingers with the application solution – your fingers should always be wet when handling WoopSkinz.

    installation-step-2
  • Step 3

    Carefully remove 1 of the WoopSkinz pieces – we recommend starting with the screen or back battery cover.

    installation-step-3
  • Step 4

    With the application solution, spray the sticky side of WoopSkinz so that it is completely wet. Carefully lay the WoopSkinz on your device, going edge-to-edge when laying it down, and slide it into place. We recommend using any cut-outs and edges as a guide for correct placement.

    installation-step-4
  • Step 5

    Keeping WoopSkinz steady with 1 hand, LIGHTLY squeegee from the center outwards, to remove excess solution and air. Do not squeegee towards openings such as the microphone or speaker. If fluid does get into these areas, blot the fluid out with a Q-Tip or towel. Using your towel, lightly pat around the edges to remove any solution that was squeegeed out.

    installation-step-5
  • Step 6

    Wet the tip of your squeegee using the solution, and then squeegee WoopSkinz again, applying slightly more pressure this time. Gently wipe away excess fluid.

    installation-step-6
  • Step 7

    Let that piece sit for a few minutes to bond to your device before moving onto the next piece. Repeat steps 2-6 until all WoopSkinz pieces are installed.

    installation-step-7
  • Step 8

    Let your device sit for 3-4 hours with the power OFF. It is normal during this curing process to see corners or edges lift up - simply push them back down, and hold them for 15 seconds with moderate pressure using your thumb or palm. After 3-4 hours your WoopSkinz will be fully cured, and you can use your device normally.

    installation-step-8